Ok, I want to try this! How do I apply this color?Updated 2 years ago
For best results, start with clean, unconditioned, dry hair. Full coverage color works best with pre-bleached platinum to pale blonde hair.
Materials to prepare:
Gloves, applicator brush, clips, bowl, & an old t-shirt or cape. Our At Home Hair Color Kit will help get you started!
- Cover all surfaces and clothing you do not want to get hair dye on. (tip: alcohol wipes just in case you get color on surfaces. immediately wipe off for less stains)
- Use petroleum jelly or coconut oil around the hairline and on ears to prevent staining on skin
- Section hair into 4 even sections (front to back and side to side) and secure with clips. Work in 1” wide strands. Apply color evenly from root to tip with applicator brush or gloved fingers.
- Begin at the root of the hair, applying color evenly through to the ends. Massage each strand with gloved fingers, root to tip, to ensure even distribution of color.
- Leave color in for 30 to 45 minutes. No heat/cap required. For more intense, longer-lasting results, leave color in for 1 hour. Don't worry, Insert Color Here has a conditioning formula, it will not damage your hair.
- Rinse hair in cool to lukewarm water until hair feels clean & dry hair fully to prevent post color transfer. More intense shades may not rinse clear for the first few washes. Do not shampoo. Conditioner is optional.
Tips & Tricks
- Always do a patch & strand test to determine the color saturation you like.
- Use isopropyl alcohol to wipe off surfaces and use eye make-up remover to help remove dye around hairlines.
- On the first day, since the color is very new, lay a towel on your pillow and make sure your hair is dry before bed to prevent stains on fabric.
- Have your bestie stand-by and assist you at hard to reach areas such as the back of hair.
How To Perform A Patch Test
- Use a cotton swab and apply a small amount of product to the skin near the nape of your neck.
- Allow it to dry and leave it on for 24 hours
- If there is any redness or irritation, discontinue use of the product
How to perform a strand test
- Take a small, 1 inch section of hair from below the ear
- Apply the color to the strand and leave it on for 45 minutes
- Rinse out the color
- If you enjoy the end result, you may proceed with coloring the rest of your hair
For more information on applying INH Semi Permanent Hair Color, check our blog here.